The 9.0kw competition series amplifier is a 9,000 watt mono block. It is capable of running up to 18 volts
for up to 11,000 watts. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped.
It comes with a bass knob and a clipping indicator. For power inputs it will accept triple 0 awg for power and triple 0 awg for ground.

 

Key Features
 1 ohm stable
 Variable low pass filter
 Variable subsonic filter
 Variable bass boost
 Wired remote control
 Triple 0 awg power and ground inputs

We recommend for installation
 1 upgraded battery under the hood
 3 extra 800ci battery in the rear
 Minimum of two 0 awg ran from the front battery to the rear batterys
 All 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 6 runs into the amp
 2 upgraded aftermarket alternators
 Dash mounted voltage meter

  Features Voltage 9.0kw
Output Power (RMS) 4 ohm 14.4V 2,400W x 1
2 ohm 4,800W x 1
1 ohm 9,000W x 1
1 ohm 16V 9,800W x 1
1 ohm 18V 11,000W x 1
Input Sensitivity     6V~0.2V
Low Pass Filter Switchable    
( @ 24 dB Slope) Variable Hz 35~250
Subsonic Filter Switchable    
( @ 24dB slope ) Variable Hz 10~50
Bass Boost Variable dB 0-9dB
Frequency Response   Hz 15-270
Signal to Noise Ratio   dB 100
Damping factor     150<
Efficiency @ 4ohm   % Over 90%
THD @ 4ohms     Less than 0.1%
Fuse Rating     900 Amps
Linked Fuse Rating     1800 Amps
Indicator Power   Yes
Protection   Yes
Clip   No
Speaker & Power terminal Mold Type    Yes
Power Gauge 0Ga x 3
Heatsink Length inch/mm   34.65"/880mm

DC Audio 9.0k - 9,000w Monoblock Amplifier

$2,300.00Price