RAGE P & PWR

Derived from the successful HNP series, the RAGE Pro is the evolution. An evolution that might not be necessary, but already possible. So instead of it being a name change from HN, it is an add on, offering tweaked products that quite frankly could be overkill. The RAGE

So what’s it all about? Most people would crossover their midrange at 4-5 KHz, right where their tweeters would be recommended as well. If that’s your settings, then the differences in the frequency range vs the HNP won’t be as audible. Still if you prefer a large slope cutoff on your crossovers, meaning a wider overlap of tweeters & midranges, the Rage is superior.
The upper frequencies of both the RAGE8″ & RAGE10″ is designed with a linear, but peaked response of up to 5 dB compared to frequencies below 3 KHz. The peak is best described as removing a slightly muffled sound compared to other speakers, the RAGE simply put, is more open and doesn’t sound as compressed as pro audio has unfairly gotten a reputation to be.

The INSIDE –
We still use the U shaped surrounds offering a longer stroke known as excursion / xmax. The U shape offers a tighter kick and extends the sound reproduction in the low end = more bass. Differing from other series, the RAGE P / PWR have fully coated cones, making them better suited for harsh sunny conditions and outdoor use. The PWR being the Weather Resistant one, has a near identical sound signature of the P series, but instead of using a phase plug, the dustcap will prevent moisture & residue to enter inside the speaker.

It’s what’s inside that counts. More than you can see makes a difference, both the P & the PWR uses copper shorting rings to lower distortion, it’s an old trick not always necessary to apply, but on pro audio it makes sense. It features added costs and skills in manufacturing, but there are clear trade off’s. Since efficiency is the key to pro audio, these drivers can get really loud, so why not opt for some that don’t sound distorted? That is the exact fact why some dislike the sound of pro audio. Many are cheaply made, using inferior parts, but designed to look stunning and impressive. Sound performance on the other hand is most likely mediocre.

Doing something right takes skill, time and knowledge. Couple those factors with a decent amount of money and you have a good sounding product. Sugar coat it with our own custom designed voice coils (2″ on RAGE8 & 3″ on RAGE10), made to handle both power and maintain efficiency you will feel the RAGE.

To summerise, those who need a waterproof Pro audio driver should opt for the RAGEPWR series. In all other cases the RAGEP Series will be the one to go for!


Manual

Specifications:

Rage6P

   

Frequency Response:

135 Hz ~ 6 KHz

Sensitivity:

99.5 dB

Nominal Impedance:

4 Ohm

DC Resistance (RE):

3.6 Ohm

Resonance Frequency (FS):

135 Hz

Power Handling:

150 Watts

QMS:

5.66

QES:

0.54

QTS: 

0.49

VAS:

5.3 L

Voice Coil Diameter:

1.5"

Recommended cut off:

 

BL^2/RE:

9.3

Depth:

3" / 78 mm

Outer Dim (Crosssection):

6.85" / 174 mm

Cutout:

5.78" / 147 mm

B2 Audio Rage 6 P (Pair) B2 Audio Rage 6 P (Pair) B2 Audio Rage 6 P (Pair)

$199.00Price